Ridgefield · Vancouver · Battle Ground · Camas · all of Clark County Free estimates · (360) 600-7880

Paver Patios & Walkways in Camas, WA

Patios carved into a slope. Interlocking paver patios, walkways and driveways built on an open-graded base that survives Clark County winters.

Free Estimate in Camas

Paver Patios & Walkways in Camas: what is different here

A flat patio in Camas usually starts with making flat ground, and that means the patio and the retaining wall are one project rather than two. We cut into the slope, build the wall that holds it, drain behind that wall properly, and then build the patio on the pad we created.

Basalt close to the surface is the wildcard on Prune Hill and above Lacamas Lake. Hitting rock changes an excavation from hours to days and needs a hammer attachment. We probe during the site visit so the number we give you accounts for it rather than arriving as a change order.

On steeper lots, Camas and Clark County critical-area and steep-slope rules can apply, and some projects need review or engineering. We raise that early, before you have made decisions based on a price that assumed none of it.

How we build it

  • Excavation to proper subgrade for the intended load
  • Geotextile separation fabric on clay and wet sites
  • Compacted base in lifts, not a single deep pour
  • Saw-cut perimeter and spiked edge restraint
  • Polymeric jointing sand, compacted and set
  • Positive drainage pitched away from the house

A paver patio is only as good as what is underneath it. Most of the failed patios we get called out to repair in Clark County look fine the day they were finished — they sank two winters later because somebody laid pavers on four inches of loose sand over clay. We build the base first and the pretty part second.

About 35 minutes east, and worth the drive for the right project. Estimates in Camas are free, and the price we put in writing is the price.

Full detail on how we build paver patios & walkways · Everything we do in Camas

Paver Patios & Walkways we have built

Paver edging set before fresh sod is rolled into place
Paver walkway and planting bed running along the side of a house
Paver walkway with a block retaining edge leading to a driveway
Large paver patio with a decorative gravel border and iron railing
Paver patio base prepped with pallets of stone staged for installation
Completed paver patio in a fenced Clark County backyard

Paver Patios & Walkways in Camas: questions we get

How long does a paver patio take to install?

A typical 400 to 600 square foot residential patio runs three to five working days once we start, assuming reasonable access and no weather delays. Larger builds with walls, steps or an outdoor kitchen run one to three weeks.

Pavers or stamped concrete — which is better here?

Pavers, in most Clark County yards. Our clay soil moves seasonally, and a poured slab is one rigid piece that cracks when the ground under it shifts. A paver field is thousands of small pieces that flex with the ground and can be individually lifted and reset. Stamped concrete looks great and costs less up front, but it is far harder to repair.

Do I need a permit for a patio?

A ground-level patio usually does not require a building permit, but jurisdictions in Clark County differ, and impervious surface limits, setbacks, easements and HOA rules can all apply. If your project touches any of those we will tell you during the walkthrough so you can confirm with your city or the county before we start.

Paver Patios & Walkways in Camas

Free on-site estimates across Clark County. We walk the property with you, tell you what it actually needs, and put a fixed price in writing.

Call (360) 600-7880 Free Estimate