Paver Patios & Walkways in Ridgefield, WA
First patios on new construction lots. Interlocking paver patios, walkways and driveways built on an open-graded base that survives Clark County winters.
Free Estimate in RidgefieldPaver Patios & Walkways in Ridgefield: what is different here
Nearly every paver patio we build in Ridgefield goes onto a lot where the builder left compacted subgrade under a thin layer of hydroseed. That ground has been driven over by loaded trucks for months. It is dense, it does not drain, and it is actually a decent subgrade for hardscape — provided we excavate to it properly and separate it from the base with fabric so the clay does not pump up into the rock.
The bigger issue on new Ridgefield lots is grade. Builders commonly leave the yard close to flat or even falling slightly back toward the house. Before we lay a single paver we correct that, because a patio pitched the wrong way channels water at your foundation for the next thirty years.
Access is usually good on these lots since fences are new and gates are standard width, which keeps costs down — we can generally get a machine into the back yard rather than wheelbarrowing every yard of base rock.
How we build it
- Excavation to proper subgrade for the intended load
- Geotextile separation fabric on clay and wet sites
- Compacted base in lifts, not a single deep pour
- Saw-cut perimeter and spiked edge restraint
- Polymeric jointing sand, compacted and set
- Positive drainage pitched away from the house
A paver patio is only as good as what is underneath it. Most of the failed patios we get called out to repair in Clark County look fine the day they were finished — they sank two winters later because somebody laid pavers on four inches of loose sand over clay. We build the base first and the pretty part second.
This is our home town — our shop and our owner both live here. Estimates in Ridgefield are free, and the price we put in writing is the price.
Full detail on how we build paver patios & walkways · Everything we do in Ridgefield
Paver Patios & Walkways we have built
Paver Patios & Walkways in Ridgefield: questions we get
How long does a paver patio take to install?
A typical 400 to 600 square foot residential patio runs three to five working days once we start, assuming reasonable access and no weather delays. Larger builds with walls, steps or an outdoor kitchen run one to three weeks.
Pavers or stamped concrete — which is better here?
Pavers, in most Clark County yards. Our clay soil moves seasonally, and a poured slab is one rigid piece that cracks when the ground under it shifts. A paver field is thousands of small pieces that flex with the ground and can be individually lifted and reset. Stamped concrete looks great and costs less up front, but it is far harder to repair.
Do I need a permit for a patio?
A ground-level patio usually does not require a building permit, but jurisdictions in Clark County differ, and impervious surface limits, setbacks, easements and HOA rules can all apply. If your project touches any of those we will tell you during the walkthrough so you can confirm with your city or the county before we start.
Paver Patios & Walkways in Ridgefield
Free on-site estimates across Clark County. We walk the property with you, tell you what it actually needs, and put a fixed price in writing.